Genelec 1238DF SAM Studio Monitor
Product Description
A Genelec Smart Active Monitor for accurate professional listening and mix decisions. The 1238DF combines active amplification with digital signal processing and GLM room-calibration support to help adapt monitoring to the listening space. Its detailed specifications and connections are listed below. Supplied as one monitor.
Supplied Configuration
One unit.
Specifications
Frequency Response
57 Hz - 20 kHz (± 2 dB)
Low cutoff -6dB
50 Hz
High cutoff -6dB
20 kHz
SPL
Peak SPL
≥124 dB
Maximum peak acoustic output per pair in a listening room with music material at 2 m.
Short term max SPL
≥117 dB
Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz at 1 m
Long term max SPL
≥107 dB
Maximum long term RMS acoustic output in the same conditions with IEC weighted noise
(limited by driver protection circuit) at 1 m.
Self-generated noise
Self-generated noise
≤10 dB SPL
Self generated noise level in free space at 1 m on axis (A-weighted).
Weight
Weight36 kg (79.4 lb)
Dimensions
Height
610 mm
Width
470 mm
Depth
235 mm
Enclosure
Enclosure material
MDF
Enclosure type
Sealed box
Drivers
Driver type
Cone
2 x 210 mm (8 in) cone
Count
2
Diameter
210 mm
Driver type
Cone
125 mm (5 in) cone
Diameter
125 mm
Driver type
Metal dome
25mm (1 in) metal dome
Diameter
25 mm
Directivity
Harmonic distortion
> 200 Hz ≤0.5 %
Group delay
The latency at high frequencies from the input to the acoustic output, measured in the analog input:
Extended Phase Linearity in GLM set to OFF
5.1 ms
In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.
Amplifiers
500 W Class D
3U rack mounted amplifier (RAM-L)
Height
132 mm
Width
483 mm
Depth
240 mm
Weight
6 kg
(13.2 lb)
250 W Class D
200 W Class AB
Mains voltage
100-240 VAC 50/60Hz
Power consumption
ISS Active
≤0.5 W
Idle
≤25 W
Full output
750 W
Connectors
Input
Analog signal input connector XLR female, balanced 10 kOhm.
Input
Digital signal input connector XLR female 110 Ohm.
Output
Digital signal output / Thru connector XLR male 110 Ohm.
2 x Control
Two CAT5 (RJ45) GLM Network connectors for computer control using the Genelec Loudspeaker Manager (GLM) software.
Crossover
Bass/Mid
420 Hz
Mid/Treble
3000 Hz