Genelec 4430A Smart IP Installation Speaker
Product Description
The Genelec 4430A brings Smart IP networked audio to a professional installation. A single network connection carries audio, power and management, simplifying system wiring and control. It integrates with Genelec Smart IP tools for commissioning and adjustment. This listing supplies one unit; network equipment is not included.
Supplied Configuration
One unit.
Specifications
Frequency Response
58 Hz - 20 kHz (± 1.5 dB)
Low cutoff -6dB
45 Hz
High cutoff -6dB
39 kHz
SPL
Peak SPL
≥107 dB
Maximum peak acoustic output per unit in a listening room with music material, at 1 m, using PoE+ power.
Short term max SPL
≥104 dB
Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz at 1 m.
Long term max SPL
≥96 dB
Maximum long term RMS acoustic output in same conditions with IEC weighted noise (limited by driver unit protection circuit) at 1 m.
Self-generated noise
Self-generated noise
≤5 dB
Self generated noise level in free field at 1m on axis(A-weighted).
Weight
Weight5.1 kg (11.2 lb)
Dimensions
Height
285 mm
Width
189 mm
Depth
178 mm
Enclosure
Enclosure material
Die cast aluminium
Enclosure type
Reflex port
Drivers
Driver type
Cone
Diameter
130 mm
Driver type
Metal dome
Diameter
19 mm
Directivity
Harmonic distortion
> 200 Hz ≤0.5 %
Group delay
The latency at high frequencies from the input to the acoustic output, measured in the analog input:
2.3 ms
In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.
Amplifiers
50 W Class D
50 W Class D
Mains voltage
PoE+/PoE
Power consumption
ISS Active
≤4 W
Idle
≤5 W
Full output
25.5 W
Connectors
Input
Ethernet (Power over Ethernet and Audio over IP)
Input
Audio input is via a 10 kOhm balanced connector.
Crossover
Bass/Treble
2900 Hz