Genelec 6040R Smart Active Loudspeaker
Product Description
A sculptural active loudspeaker that brings Genelec Smart Active Monitoring into home and professional listening spaces. The 6040R combines integrated amplification with GLM room-calibration support for consistent playback in its surroundings. Choose from the standard enclosure and grille combinations. Supplied as one loudspeaker.
Supplied Configuration
One unit.
Specifications
Frequency Response
50 Hz - 20 kHz (± 1.5 dB)
Low cutoff -6dB
43 Hz
High cutoff -6dB
20 kHz
SPL
Peak SPL
≥118 dB
Maximum peak acoustic output per pair in a listening room with music material at 1 m.
Short term max SPL
≥109 dB
Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz at 1 m.
Long term max SPL
≥98 dB
Maximum long term RMS acoustic output in the same conditions with IEC weighted noise (limited by driver protection circuit) at 1 m.
Self-generated noise
Self-generated noise
≤5 dB SPL
Self generated noise level in free space at 1 m on axis (A-weighted).
Weight
Weight14.9 kg (32.8 lb)
Dimensions
Height
999 mm
Width
237 mm
Depth
220 mm
Enclosure
Enclosure material
Die cast aluminium
Enclosure type
Sealed box
Drivers
Driver type
Cone
Magnetically shielded bass driver.
Diameter
165 mm
Driver type
Metal dome
Magnetically shielded treble driver.
Diameter
19 mm
Directivity
Harmonic distortion
Group delay
The latency at high frequencies from the input to the acoustic output, measured in the analog input:
Extended Phase Linearity in GLM set to OFF
2.9 ms
In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.
Amplifiers
150 W Class D
150 W Class D
Mains voltage
100-240 VAC 50/60Hz
Power consumption
ISS Active
≤1 W
Idle
≤12 W
Full output
180 W
Connectors
Input
Analog signal input connector XLR female, balanced 10 kOhm.
Input
Digital signal input connector XLR female 110 Ohm.
Output
Digital signal output / Thru connector XLR male 110 Ohm.
2 x Control
Two CAT5 (RJ45) GLM Network connectors for computer control using the Genelec Loudspeaker Manager (GLM) software.