Genelec 8330A-ACK Stereo SAM Monitor Bundle
Product Description
Build a calibrated stereo setup with two 8330A SAM monitors in Dark Grey, a GLM User Kit and a 9310BM volume controller. The compact active monitors work with Genelec GLM room calibration, while the included controller provides convenient adjustment of the system listening level.
Supplied Configuration
One stereo bundle: two monitors, GLM User Kit and 9310BM controller.
Two 8330A Dark Grey monitors, GLM User Kit and 9310BM volume controller.
Specifications
Frequency Response
58 Hz - 20 kHz (± 1.5 dB)
Low cutoff -6dB
45 Hz
High cutoff -6dB
23 kHz
SPL
Peak SPL
≥110 dB
Maximum peak acoustic output per pair at 1 m distance with music material.
Short term max SPL
≥104 dB
Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz at 1 m.
Long term max SPL
≥96 dB
Maximum long term RMS acoustic output in the same conditions with IEC weighted noise (limited by driver unit protection circuit) at 1 m.
Self-generated noise
Self-generated noise
≤5 dB SPL
Self generated noise level in free field on axis (A-weighted).
Weight
Weight5.1 kg (11.2 lb)
Dimensions
Height
285 mm
Height with Iso-Pod
299 mm
Width
189 mm
Depth
178 mm
Enclosure
Enclosure material
Die cast aluminium
Enclosure type
Reflex port
Drivers
Driver type
Cone
Diameter
130 mm
Driver type
Metal dome
Diameter
19 mm
Directivity
Harmonic distortion
> 100 Hz ≤0.5 %
Group delay
The latency at high frequencies from the input to the acoustic output, measured in the analog input:
Extended Phase Linearity in GLM set to OFF
2.9 ms
In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.
Amplifiers
50 W Class D
50 W Class D
Mains voltage
100-240 VAC 50/60Hz
Power consumption
ISS Active
≤0.5 W
Idle
≤3 W
Full output
50 W
Connectors
Input
Analog signal input connector XLR female, balanced 10 kOhm.
Input
XLR female IN
Output
XLR male OUT
2 x Control
Two CAT5 (RJ45) GLM Network connectors for computer control using the Genelec Loudspeaker Manager (GLM) software.