Genelec 8361A SAM Studio Monitor
Product Description
A Genelec Smart Active Monitor for accurate professional listening and mix decisions. The 8361A combines active amplification with digital signal processing and GLM room-calibration support to help adapt monitoring to the listening space. Its detailed specifications and connections are listed below. Supplied as one monitor.
Supplied Configuration
One unit.
Specifications
Frequency Response
36 Hz - 20 kHz (± 1.5 dB)
Low cutoff -6dB
30 Hz
High cutoff -6dB
43 kHz
SPL
Peak SPL
≥124 dB
Short term max SPL
≥118 dB
Long term max SPL
≥109 dB
Maximum long term RMS acoustic output in the same conditions with IEC weighted noise (limited by driver protection circuit) at 1 m.
Self-generated noise
Self-generated noise
≤5 dB SPL
Self generated noise level in free space at 1 m on axis (A-weighted)
Weight
Weight31.9 kg (70.3 lb)
Dimensions
Height
570 mm
Height with Iso-Pod
593 mm
Width
357 mm
Depth
347 mm
Enclosure
Enclosure material
Die cast aluminium
Enclosure type
Reflex port
Drivers
Driver type
Racetrack
Dual 263 x 137 mm (103/8 x 53/8 in) obround cones
Count
2
Width
263 mm
Height
137 mm
Driver type
Coaxial
8361A midrange driver cone (coaxial)
Diameter
130 mm
Driver type
Coaxial
8361A treble driver metal dome (coaxial)
Diameter
25 mm
Directivity
Harmonic distortion
> 100 Hz ≤0.5 %
Group delay
The latency at high frequencies from the input to the acoustic output, measured in the analog input:
Extended Phase Linearity in GLM set to OFF (top graph)
4.2 ms
Extended Phase Linearity in GLM set to ON (bottom graph)
8.6 ms
In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.
Amplifiers
700 W Class D
150 W Class D
150 W Class D
Mains voltage
100-240 VAC 50/60Hz
Power consumption
ISS Active
≤1.5 W
Idle
≤20 W
Full output
600 W
Connectors
2 x Control
Two CAT5 (RJ45) GLM Network connectors for computer control using the Genelec Loudspeaker Manager (GLM) software.
Input
Analog signal input connector XLR female, balanced 10 kOhm.
Input
Digital signal input connector XLR female 110 Ohm.
Output
Digital signal output / Thru connector XLR male 110 Ohm
Crossover
Bass/Mid
320 Hz
Mid/Treble
2800 Hz