Genelec S360A-R Rack-Amplifier Monitor Package
Product Description
A factory-preconfigured S360A monitoring system with its matched amplifier installed in a separate rack chassis. This arrangement moves the amplifier away from the loudspeaker while retaining a calibrated monitor-and-amplifier pairing. The package ships in two cartons; interconnecting cables are not included.
Supplied Configuration
One monitor plus its separate matched rack-mounted amplifier.
Factory-preconfigured monitor with its matched amplifier installed in a separate rack-mount chassis. Monitor and amplifier share the same serial number and form one calibrated system. Interconnecting cables are not included. Delivered in two packages.
Photo shows the monitor enclosure. The supplied configuration places its amplifier in a separate rack chassis.
Specifications
Frequency Response
39 Hz - 19 kHz (± 2 dB)
Low cutoff -6dB
36 Hz
High cutoff -6dB
22 kHz
SPL
Peak SPL
≥128 dB
Maximum peak acoustic output per pair in a listening room with music material at 1 m.
Short term max SPL
≥118 dB
Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz at 1 m.
Long term max SPL
≥112 dB
Maximum long term RMS acoustic output in the same conditions with IEC weighted noise (limited by driver protection circuit) at 1 m.
Self-generated noise
Self-generated noise
≤10 dB SPL
Self generated noise level in free space at 1 m on axis (A-weighted).
Weight
Weight30 kg (66.1 lb)
Dimensions
Height
530 mm
Height with Iso-Pod
530 mm
Width
360 mm
Depth
360 mm
Enclosure
Enclosure material
MDF
Enclosure type
Reflex port
Drivers
Driver type
Cone
Diameter
250 mm
Driver type
Compression
Compression driver 44 mm (1.7 in) into a 25 mm (1 in) throat.
Diameter
25 mm
Directivity
Harmonic distortion
100 Hz...5 kHz ≤0.5 %
> 5 kHz ≤1.5 %
Group delay
The latency at high frequencies from the input to the acoustic output, measured in the analog input:
Extended Phase Linearity in GLM set to OFF
5.2 ms
In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.
Amplifiers
250 W Class D
100 W Class D
Mains voltage
100-240 VAC 50/60Hz
Power consumption
ISS Active
≤1 W
Idle
≤11 W
Full output
230 W
Connectors
Input
Analog signal input connector XLR female, balanced 10 kOhm.
Input
Digital signal input connector XLR female 110 Ohm.
Output
Digital signal output / Thru connector XLR male 110 Ohm.
2 x Control
Two CAT5 (RJ45) GLM Network connectors for computer control using the Genelec Loudspeaker Manager (GLM) software.