The ELAC Miracord 50 combines a belt-driven aluminium platter with a static-balanced tonearm and a pre-mounted Audio-Technica AT91 moving-magnet cartridge. Its switchable built-in phono preamplifier supports connection to suitable phono or line-level amplifier inputs.
| Sale unit | One turntable |
|---|---|
| TURNTABLE SECTION | |
| Drive System | Belt drive |
| Motor | DC motor |
| Selectable Speeds | 33⅓ and 45 rpm |
| Motor Servo | Speed rotation and servo system |
| Rotation Speed Varia | +/-1% |
| Wow and Flutter | 0.10% |
| Signal-to-Noise Ratio | -67 dB or higher (A-weighted) |
| Signal-to-Noise Ratio | -60 dB or higher (unweighted) |
| Platter | Aluminum die-cast |
| Platter Diameter | 12.0 in / 300 mm |
| Tonearm type | Aluminium tube, static-balanced |
| Effective arm length | 8.8 in / 223.6 mm |
| Stylus pressure range | 0 to 4.0 g |
| Cartridge weight range | 3.5 to 6.0 g |
| Effective arm mass | 27.4 g |
| Overhang | 18.6 mm |
| Offset angle | 25 degrees |
| Anti-skating adjustment | Supported |
| Tonearm main bearing | Stainless steel |
| Cartridge type | Audio-Technica AT91 moving magnet |
| Stylus construction | Bonded diamond |
| Cartridge mount | Half-inch |
| Cartridge frequency response | 20 Hz to 20 kHz |
| Channel separation | >18 dB |
| Channel balance | 2.5 dB |
| Vertical tracking angle | 20 degrees |
| Stylus pressure | 2.0 g ±0.5 g |
| Cartridge weight | 5.0 g ±0.5 g |
| Headshell weight | 11.0 g including screws, nuts and wires |
| Phono equalizer amplifier type | Moving magnet (MM) |
| Phono output | 2.5 mV (1 kHz, 3.54 cm/sec) |
| Line output | 140 mV (-17 dBV) |
| Phono / line | Switchable |
| Supported load impedance | 47 kΩ |
| Connector | RCA pin jack, including RCA cable accessories |
| Voltage | 100 to 240 V AC / 50 to 60 Hz |
| Power consumption | 1.5 W; less than 0.5 W at standby |
| Dimensions (published W × H × D) | 5.5 × 16.05 × 14.20 in |
| Weight | 12.10 lb |